SENSOR, Camshaft Position: Installation: Installation

Fig 1: CMP REMOVAL / INSTALLATION

Courtesy of CHRYSLER LLC

1. Clean out the machined hole in the timing cover.
2. Install the CMP sensor (2) into the timing cover with a slight rocking motion. Do not the twist sensor into position as damage to O-ring may result.
   CAUTION: Before tightening the CMP sensor retaining bolt, be sure the sensor is completely flush to the timing cover. If the sensor is not flush, damage to the sensor mounting tang may result.
3. Install the retaining bolt (3) and tighten to 12 N.m (9 ft. lbs.).
   Fig 2: CAMSHAFT POSITION SENSOR

   Courtesy of CHRYSLER LLC
4. Connect the electrical connector (4) to the CMP sensor (1).
5. Install the air cleaner and resonator assembly.