SEAL, Input Flange: Removal: Removal
WARNING: This page is about a different variant/trim than selected.
- Raise the vehicle on a hoist.
- Remove the propeller shaft. Refer to Differential and Driveline/Propeller Shaft - Removal .
- Unplug the electrical connector (3) at the ECC.
- Disconnect ECC breather hose.
- Remove the ECC to RDA mounting bolts.
- Separate and lower ECC.
- Remove all old gasket material on the mating surfaces of the ECC and RDA. Remove wave washer
- Remove wave washer.
- Remove the input flange seal.