LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2010 >> Commander Limited, RWD >> Repair and Diagnosis (Single Page) >> Electrical >> Body Electrical >> Electronic Control Modules (Service Information) >> MODULE, Memory >> Removal >> Removal

MODULE, Memory: Removal: Removal

Fig 1: Removing/Installing Memory Seat Module
GC0118366Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the driver seat cushion/cover (2). Refer to Body/Seats/COVER, Seat Cushion - Removal .
  3. Pivot the module upward and disconnect the electrical connectors (1).
  4. Unsnap the memory seat module (4) from the side brackets.
  5. Pull the module rearward to remove it from the front of the seat frame (3).
scientia non olet · About LEMON Manuals