LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2009 >> Wrangler X, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 ((Transmission Control Module (TCM) - Electrical Diagnostics)) >> DTC Troubleshooting >> P0736-Gear Ratio Error In Reverse >> Possible Causes

Possible Causes

WARNING: This page is about a different variant/trim than selected.
Possible Causes 
LOW FLUID LEVEL
CUT L/R TOWER SEAL ON MAIN VALVE BODY
CUT L/R CLUTCH PISTON SEALS
BROKEN OR MISSING L/R CLUTCH BLEED ORIFICE (IN L/R CLUTCH RETAINER)
CUT L/R ACCUMULATOR PISTON SEAL IN MAIN VALVE BODY
CRACKED L/R ACCUMULATOR PISTON IN MAIN VALVE BODY
CUT OD/REV PISTON SEALS
BROKEN OR MISSING OD/REV BLEED ORIFICE (IN OD/REV CLUTCH PISTON)
BROKEN REVERSE CARRIER HUB WELD
BROKEN REVERSE SUN GEAR WELD TO THE REACTION CARRIER

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. See  DTC-Based Diagnostics/MODULE, Transmission Control (TCM) - Standard Procedure  .