LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2009 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> ( Electrical Diagnostics - ECM Verification Test, Pcm/ECM/TCM Programming, Pre-Diagnostic Troubleshooting Procedure & Intermittent DTC) >> Standard Procedure >> Pcm/ECM/TCM Programming >> REPAIR PROCEDURE - wiTECH™ Diagnostic Application

REPAIR PROCEDURE - wiTECH™ Diagnostic Application

NOTE: If this flash process is interrupted or aborted, the flash should be restarted.
  1. Open the hood of the vehicle and install a battery charger. Verify that the charging rate provides a continuous charge of 13.2 - 13.5 Volts.
  2. Connect the wiTECH™ Vehicle Connection Interface (VCI) pod to the vehicle data link connector located under the steering column and turn the ignition key to the "RUN" position.
  3. Launch the wiTECH™ Diagnostic Application and connect to the appropriate wiTECH™ device.
  4. From the wiTECH™ Diagnostic Application Home screen,
    1. Select "HELP"
    2. Select "HELP CONTENTS"
    3. Follow the "HELP TOPIC" for flashing an ECU.
scientia non olet · About LEMON Manuals