AIR BAG, Passenger: Assembly: Bracket
WARNING:
Disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, Occupant Classification System (OCS), seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.
WARNING:
To avoid serious or fatal injury, service of this unit should be performed only by Chrysler-trained and authorized dealer service technicians. Failure to take the proper precautions or to follow the proper procedures could result in accidental, incomplete, or improper airbag deployment and possible occupant injuries.
WARNING:
To avoid serious or fatal injury, use extreme care to prevent any foreign material from entering the passenger airbag, or becoming entrapped between the passenger airbag cushion and the passenger airbag door. Failure to observe this warning could result in occupant injuries upon airbag deployment.
- Place the passenger airbag on a suitable work surface with the housing (1) facing up. Be certain to take the proper precautions to prevent the airbag door from receiving cosmetic damage during the following procedures.
- Carefully position the passenger airbag instrument panel bracket (3) over the two studs on the top of the airbag housing.
- Install and tighten the two nuts (2) that secure the bracket to the studs on the housing. Tighten the nuts to 20 N.m (15 ft. lbs.).
- Reinstall the passenger airbag onto the instrument panel. See Restraints/AIR BAG, Passenger - Installation .