Diagnostic Test

DTC IS ACTIVE
1. Ignition on, engine not running.
2. With the scan tool, Clear DTCs.
3. Monitor the scan tool for at least two minutes.
4. Cycle the ignition key off and on several times, leaving the ignition on for at least 10 seconds at a time.
5. Start the engine.
6. Allow the engine to reach normal operating temperature.
7. With the scan tool, select View DTCs.
  Is the status Active for this DTC?
  
  Yes
  - Go to step 2
  No
  - Refer to the INTERMITTENT DTC Diagnostic Procedure. See DTC-Based Diagnostics/MODULE, Engine Control (ECM) - Standard Procedure
GLOW PLUG MODULE
1. Using the wiring diagram/schematic as a guide, inspect the Glow Plug Module wiring and connectors.
2. Look for any chafed, pierced, pinched, or partially broken wires.
3. Look for broken, bent, pushed out or corroded terminals.
4. Monitor the scan tool data relative to this circuit and wiggle test the wiring and connectors.
5. Look for the data to change or for the DTC to reset during the wiggle test.
6. Refer to any Technical Service Bulletins that may apply.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the ECM Verification Test. See DTC-Based Diagnostics/MODULE, Engine Control (ECM) - Standard Procedure
  No
  - Replace the Glow Plug Module in accordance with the Service Information.
  - Perform the ECM Verification Test. See DTC-Based Diagnostics/MODULE, Engine Control (ECM) - Standard Procedure