Charging System (Service Information): Generator: Removal: Removal

Fig 1: Lower Air Dam

Courtesy of CHRYSLER LLC

1. Disconnect and isolate negative battery cable at battery.
2. Remove the right front wheel.
3. Remove the underbody air dam.
   Fig 2: Idler Pulley Location

   Courtesy of CHRYSLER LLC
4. Remove the accessory drive splash shield.
   Fig 3: Idler Pulley Removal/Install

   Courtesy of CHRYSLER LLC
5. Remove the accessory drive idler pulley.
   Fig 4: Lower Mounting Bolt Loose

   Courtesy of CHRYSLER LLC
6. Loosen the lower mounting bolt.
   Fig 5: A/C Compressor Relocation

   Courtesy of CHRYSLER LLC
7. Loosen the A/C compressor and relocate, pull down and to outboard side of vehicle to make room to remove generator.
   Fig 6: Field Connection

   Courtesy of CHRYSLER LLC
8. Unplug field circuit from generator.
   Fig 7: Battery Cable Connection

   Courtesy of CHRYSLER LLC
9. Remove the B+ terminal nut and wire.
   Fig 8: Upper Mounting Bolt

   Courtesy of CHRYSLER LLC
10. Remove the upper mounting bolt.
11. Remove the generator lower mounting bolt.
    Fig 9: Battery Stud Location

    Courtesy of CHRYSLER LLC
12. Relocate the battery terminal (1) to the other side of the A/C line (2) for removal of the generator.
    Fig 10: Rotate Generator

    Courtesy of CHRYSLER LLC
13. Rotate generator pulley down.
    Fig 11: Generator Removal/Installation

    Courtesy of CHRYSLER LLC
14. Slide generator down and out of vehicle.