Diagnostic Test
- VERIFY THAT DTC B223B-VEHICLE CONFIGURATION MISMATCH IS ACTIVE
- Turn the ignition on.
- With the scan tool, read ORC DTCs.NOTE: Make sure the battery is fully charged.
Does the scan tool display active: B223B-VEHICLE CONFIGURATION MISMATCH?
Yes
- Go to step 2
No
- If the DTC is stored, check for an intermittent condition. Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.
- Perform the ORC VERIFICATION TEST. See DTC-Based Diagnostics/CONTROLLER, Occupant Restraint (ORC) - Standard Procedure .
- COMPARE STORED VIN IN THE PCM AND ORC
- With the scan tool, read and record the VIN that is stored in the PCM.
- With the scan tool, read and record the VIN that is stored in the ORC.
Does the VIN stored in the PCM and ORC match?
Yes
- Replace the Occupant Restraint Controller in accordance with the service information.
- Perform the ORC VERIFICATION TEST. See DTC-Based Diagnostics/CONTROLLER, Occupant Restraint (ORC) - Standard Procedure .
WARNING: Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.No
- Replace and program the Powertrain Control Module in accordance with the Service Information. Make sure the PCM is replaced with the correct VIN. Refer to DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure .