Diagnostic Test

WARNING: This page is about a different car, the 2008 Jeep Commander. However, it is still accessible from the selected car via links, so may be relevant.

VERIFY DTC IS ACTIVE
NOTE: Ensure the IOD fuse is installed and battery voltage is between 10 and 16 volts before proceeding.

With the scan tool, read active DTCs.

Is this DTC active?

Yes
1. Go To 2.
No
1. Refer to the Stored Lost Communication test procedure. Refer to DIAGNOSTIC CODE INDEX table.
CHECK FOR ANY OF THE FOLLOWING ACTIVE DTCS
With the scan tool, read active DTCs from all modules.

NOTE: Check for FCM configuration, CAN B or C hardware electrical, VIN Missing/Mismatch, battery or ignition related DTCs.

Does the scan tool display any active DTCs to the conditions listed above?

Yes
1. Diagnose and repair the DTC. Refer to DIAGNOSTIC CODE INDEX table for a complete list of the symptoms. Refer to appropriate Engine ELECTRICAL DIAGNOSTICS article for PCM DTCs.
No
1. Go To 3.
VERIFY THAT THE SCM IS ACTIVE ON THE BUS
Turn the ignition on.

With the scan tool, select Network Diagnostics.

Verify that the SCM is active on the bus.

Is the SCM active on the bus?

Yes
1. Go To 4.
No
1. Refer to DIAGNOSTIC CODE INDEX for a no response test procedure.
CHECK FOR ADDITIONAL COMMUNICATION RELATED DTCS
With the scan tool, select Network Diagnostics.

Is there more than one module with active DTCs "Logged Against" the SCM?

Yes
1. Replace/update the Steering Control Module in accordance with the service information.
2. Perform BODY VERIFICATION TEST .
No
1. Replace/update the module that set this DTC in accordance with the service information.
2. Perform the appropriate VERIFICATION TEST.