LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2009 >> Commander Overland, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (3.7L Engine (Service Information)) >> Lubrication >> Sensor/Switch-Oil Pressure >> Removal >> Oil Pressure Sensor/Switch

Oil Pressure Sensor/Switch

WARNING: This page is about a different car, the 2008 Jeep Commander. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Oil Pressure Sending Unit
GC0011823Courtesy of CHRYSLER LLC
  1. Disconnect the negative cable from the battery.
  2. Raise vehicle on hoist.
  3. Remove front splash shield.
  4. Disconnect oil pressure switch connector (4).
  5. Remove the pressure switch (2).
scientia non olet · About LEMON Manuals