Diagnostic Test

WARNING: This page is about a different car, the 2009 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, record and erase the DTCs.
3. Operate the Driver Passenger Window Switch in all positions several times.
4. Wait 30 seconds.
5. With the scan tool, read the active DTCs.
  Does the scan tool display B1868-DRIVER PASSENGER WINDOW SWITCH CIRCUIT STUCK?
  
  Yes
  - Go to step 2
  No
  - The conditions that caused this code to set are not present at this time. Using the SYSTEM WIRING DIAGRAMS as a guide, inspect the wiring and connectors.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Front Control (FCM) - Standard Procedure .
DRIVER WINDOW SWITCH SHORTED

Fig 1: Checking Driver Window Switch Shorted
Courtesy of CHRYSLER LLC
1. With the scan tool, erase the DTCs.
2. Disconnect the Driver Window/Door Lock Switch C2 connector.
3. With the scan tool, read the active DTCs.
  Does the scan tool display B1868-DRIVER PASSENGER WINDOW SWITCH CIRCUIT STUCK?
  
  No
  - Replace the Driver Express Window/Door Lock Switch.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Front Control (FCM) - Standard Procedure .
  Yes
  - Go to step 3
(Q222) MASTER SWITCH RIGHT FRONT WINDOW MUX CIRCUIT SHORT TO GROUND

Fig 2: Checking Master Switch Right Front Window MUX Circuit Short To Ground
Courtesy of CHRYSLER LLC
1. Turn the ignition off.
2. Disconnect the Driver Door Module C2 connector.
3. Measure the resistance between ground and the (Q222) Master Switch Right Front Window MUX circuit.
  Is the resistance below 10,000 ohms?
  
  Yes
  - Repair the (Q222) Master Switch Right Front Window MUX circuit for a short to ground.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Front Control (FCM) - Standard Procedure .
  No
  - Go to step 4
(Q222) MASTER SWITCH RIGHT FRONT WINDOW MUX CIRCUIT SHORT TO (Q994) DRIVER EXPRESS SWITCH RETURN CIRCUIT

Fig 3: Checking Master Switch Right Front Window MUX Circuit Short To Driver Express Switch Return Circuit
Courtesy of CHRYSLER LLC
1. Measure the resistance between the (Q222) Master Switch Right Front Window MUX circuit and the (Q994) Driver Express Switch Return circuit.
  Is the resistance below 10,000 ohms?
  
  Yes
  - Repair the (Q222) Master Switch Right Front Window MUX circuit for a short to the (Q994) Driver Express Switch Return circuit.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Front Control (FCM) - Standard Procedure .
  No
  - Replace the Driver Door Module in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Front Control (FCM) - Standard Procedure .