LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2009 >> Commander Overland, RWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System (Service Information) >> Generator >> Removal >> 3.0L - Diesel

3.0L - Diesel

Fig 1: Removing/Installing Generator - Diesel
GC0118407Courtesy of CHRYSLER LLC
WARNING: DISCONNECT NEGATIVE CABLE FROM BATTERY BEFORE REMOVING BATTERY OUTPUT WIRE (B+ WIRE) FROM GENERATOR. FAILURE TO DO SO CAN RESULT IN INJURY OR DAMAGE TO ELECTRICAL SYSTEM.
  1. Disconnect negative battery cable at battery.
  2. Remove plastic dress-up cover at top of engine.
  3. Remove coolant reservoir tank mounting bolt and position tank toward rear of engine compartment.
  4. Remove air filter cover and air filter element.
  5. Remove air filter housing (one bolt).
  6. Remove generator drive belt. Refer to COOLING for procedure.
  7. Remove two generator upper mounting bolts (1).
  8. Raise vehicle.
  9. If equipped, remove skid plate below generator.
    Fig 2: Generator Electrical Connectors - Diesel
    GC0118406Courtesy of CHRYSLER LLC
  10. Disconnect field wire connector (5) at rear of generator (4) by pushing on connector tab.
    Fig 3: Generator Mounting Bolts - Diesel
    GC0118405Courtesy of CHRYSLER LLC
  11. Remove two generator lower mounting bolts (2).
    Fig 4: Generator Electrical Connectors - Diesel
    GC0118406Courtesy of CHRYSLER LLC
  12. Lower vehicle.
  13. Remove throttle body-to-cylinder head support bracket (four bolts).
  14. Remove throttle body (four bolts). Refer to REMOVAL .
  15. Unsnap plastic insulator cap from B+ output terminal.
  16. Remove B+ terminal mounting nut (2) at top/rear of generator and remove cable eye (1) from mounting stud (3).
  17. Remove generator from vehicle.
scientia non olet · About LEMON Manuals