LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2009 >> Commander Overland, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> Module, Front Control >> Removal >> Removal

Module, Front Control: Removal: Removal

Fig 1: Removing/Installing Front Control Module
GC0118377Courtesy of CHRYSLER LLC
CAUTION: Front Control Module (FCM) damage may occur if the module case comes in contact with the battery while still connected. Always disconnect the battery negative cable prior to removal of the FCM.
  1. Disconnect and isolate the battery negative cable.
  2. Remove the Integrated Power Module (IPM) from the engine compartment. Refer to Electrical/Power Distribution/MODULE, Integrated Power (IPM) - Removal .
  3. Remove the four fasteners (2) securing the Front Control Module (FCM) (1) to the IPM (3).
  4. Separate the FCM from the IPM by pulling the two straight away from each other to disengage the electrical connector.
scientia non olet · About LEMON Manuals