Section 1 (3.7L Engine (Service Information)): Specifications: Torque
WARNING: This page is about a different variant/trim than selected.
TORQUE
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. |
|---|---|---|---|
| Camshaft | - | - | - |
| Non - Oiled Sprocket Bolt | 122 | 90 | - |
| Bearing Cap Bolts | 11 | - | 100 |
| Counterbalance Shaft Retaining Bolt | 28 | - | 250 |
| Timing Chain Cover Bolts | 58 | 43 | - |
| Connecting Rod Cap Bolts | 27 | 20 | - |
| - | PLUS 90° TURN | ||
| Bed Plate Bolts | Refer to Procedure | ||
| Crankshaft Damper Bolt | 175 | 130 | - |
| Cylinder Head Bolts | - | - | - |
| M11 Bolts | Refer To Procedure | ||
| M8 Bolts | Refer To Procedure | ||
| Cylinder Head Cover Bolts and Studs | 12 | - | 105 |
| Exhaust Manifold Bolts | 25 | 18 | - |
| Exhaust Manifold Heat Shield Nuts | 8 | - | 72 |
| - | Then loosen 45° | ||
| Flexplate Bolts | 95 | 70 | - |
| Engine Mount Bracket to Block Bolts | 61 | 45 | - |
| Engine to Transmission Bellhousing Bolts | 41 | 30 | - |
| Rear Mount to Transmission Bolts | 46 | 34 | - |
| Generator Mounting Bolts | - | - | - |
| M10 Bolts | 54 | 40 | - |
| M8 Bolts | 28 | - | 250 |
| Intake Manifold Bolts | 12 | - | 105 |
| - | Refer to Procedure for Tightening Sequence | ||
| Oil Pan Bolts | 16 | - | 140 |
| Oil Pan Drain Plug | 34 | 25 | - |
| Oil Pump Bolts | 28 | - | 250 |
| Oil Pump Cover Bolts | 12 | - | 105 |
| Oil Pickup Tube Bolt and Nut | 28 | - | 250 |
| Oil Dipstick Tube to Engine Block Bolt | 15 | - | 130 |
| Oil Fill Tube Bolts | 12 | - | 105 |
| Timing Chain Guide Bolts | 28 | - | 250 |
| Timing Chain Tensioner Arm | 28 | - | 250 |
| Hydraulic Tensioner Bolts | 28 | - | 250 |
| Timing Chain Primary Tensioner Bolts | 28 | - | 250 |
| Timing Drive Idler Sprocket Bolt | 34 | 25 | - |
| Thermostat Housing Bolts | 12 | - | 105 |
| Water Pump Bolts | 58 | 43 | - |