LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2009 >> Commander Overland, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Electronic Control Modules (Service Information)) >> Electronic Control Modules >> Module-Engine Control >> Installation >> Engine Control Module (ECM)

Engine Control Module (ECM)

WARNING: This page is about a different car, the 2008 Jeep Commander. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Engine Control Module (ECM)
GC0045388Courtesy of CHRYSLER LLC
1 - ECM ELECTRICAL CONNECTORS
2 - ENGINE CONTROL MODULE (ECM)
3 - ECM MOUNTING BRACKET
4 - ECM MOUNTING BRACKET MOUNTING STUDS
5 - MOUNTING BRACKET RETAINING NUTS
  1. Install Engine Control Module (ECM) on bracket (3).
  2. Position ECM and bracket assembly in vehicle.
  3. Install ECM bracket to inner fender retaining nuts (5).
  4. Connect ECM electrical connectors (1).
  5. Connect negative battery cable.
scientia non olet · About LEMON Manuals