LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2009 >> Commander Overland, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Anti-Theft Systems >> Power Liftgate System (Service Information) >> Drive Unit >> Removal >> Removal

Drive Unit: Removal: Removal

Fig 1: Identifying Liftgate Motor
GC0132171Courtesy of CHRYSLER LLC
  1. Open the liftgate.
  2. Disconnect and isolate the battery negative cable.
  3. Remove the link rod assembly from the liftgate attachment point. See Removal  .
  4. Remove the left rear D-pillar trim panel from the vehicle. Refer to Body/Interior/PANEL, D-Pillar Trim - Removal .
  5. Remove the left quarter trim panel. Refer to Body/Interior/PANEL, Quarter Trim - Removal .
  6. Disconnect the wire harness connector from the power liftgate drive unit assembly (1).
  7. Remove the drive unit assembly retaining bolts (5).
  8. Remove the drive unit assembly retaining nut (4).
  9. Unhook the drive unit assembly (1) from the D-pillar (2) and remove the unit from the vehicle.
scientia non olet · About LEMON Manuals