LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Wrangler Sahara, Standard >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Suspension System (Service Information) >> Front >> Stabilizer Bar >> Installation >> Stabilizer Bar

Stabilizer Bar

Fig 1: Identifying Stabilizer Bar Bracket Components
GC0063430Courtesy of CHRYSLER LLC
  1. Install the stabilizer bar (1) to the vehicle.
    NOTE: Stabilizer bar link to axle bolt should be tightened with vehicle sitting on its tires
  2. Install the right side stabilizer bar bracket bolts (3) to the frame. Tighten to 102 N.m (75 ft. lbs.).
  3. Install the left side stabilizer bar bracket bolts (3) to the frame. Tighten to 102 N.m (75 ft. lbs.).
  4. Install the splash shield.
    Fig 2: Identifying Stabilizer Link (Right) Components
    GC0063455Courtesy of CHRYSLER LLC
  5. Install the right upper stabilizer bar link nut (2) to the stabilizer bar. Tighten to 102 N.m (75 ft. lbs.).
    Fig 3: Identifying Stabilizer Link (Left) Components
    GC0063437Courtesy of CHRYSLER LLC
  6. Install the left upper stabilizer bar link nut (1) to the stabilizer bar. Tighten to 102 N.m (75 ft. lbs.).
  7. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals