LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Compass Limited, AWD, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (2.0L Engine (Service Information)) >> Engine Mounting >> Mount-Rear >> Installation >> Installation

Engine Mounting: Mount-Rear: Installation: Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Rear Mount
GC0054715Courtesy of CHRYSLER LLC
  1. Position rear mount (3).
  2. Install rear mount retaining bolts (4) and tighten to 50 N.m (37 ft. lbs.).
  3. Install rear mount through bolt (1) and tighten to 47 N.m (35 ft. lbs.).
  4. Install oxygen sensor connector (2) retainer to mount (3).
scientia non olet · About LEMON Manuals