LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Commander Overland, 4WD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Overhead Console (Service Information) >> Overhead Console - Service Information >> Universal Transmitter >> Standard Procedure >> Erasing Transmitter Codes

Erasing Transmitter Codes

NOTE: Individual channels cannot be erased. Erasing the transmitter codes will erase ALL programmed codes.

To erase programming from the three buttons (individual buttons cannot be erased but can be "reprogrammed"  - note below), follow the step noted:

  1. Press and hold the two outer HomeLink® buttons and release only when the Electronic Vehicle Information Center (EVIC) display shows "Channels Cleared"  (after 20 seconds). Release both buttons. Do not hold for longer that 30 seconds. HomeLink® is now in the train (or learning) mode and can be programmed at any time, see STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals