LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Commander Base, 4.7 N, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (NV245 Transfer Case (Service Information)) >> Transfer Case - NV245 - Service Information >> Removal >> Transfer Case - NV245

Transfer Case - NV245

WARNING: This page is about a different variant/trim than selected.
Fig 1: Identifying Shift Motor, Fill And Drain Plugs
GC0027439Courtesy of CHRYSLER LLC
1 - FILL PLUG
2 - DRAIN PLUG
3 - SHIFT MOTOR AND MODE SENSOR ASSEMBLY
  1. Shift transfer case into NEUTRAL.
  2. Raise vehicle.
  3. Remove transfer case drain plug (2) and drain transfer case lubricant. See Fig 1.
    Fig 2: Removing/Installing NV245 Transfer Case
    GC0027349Courtesy of CHRYSLER LLC
    1 - NV245 TRANSFER CASE
    2 - NUTS
    3 - TRANSMISSION
    4 - TRANSFER CASE VENT TUBE
  4. Support transmission (3) with jack stand.
  5. Remove rear crossmember and skid plate, if equipped.
  6. Disconnect front propeller shaft from transfer case at companion flange. Remove rear propeller shaft from vehicle. Refer to REMOVAL .
    CAUTION: Do not allow propshafts to hang at attached end. Damage to joint can result.
  7. Disconnect the transfer case shift motor and mode sensor connector.
  8. Disconnect transfer case vent hose (4). See Fig 2.
  9. Support transfer case (1) with transmission jack.
  10. Secure transfer case to jack with chains.
  11. Remove nuts (2) attaching transfer case to transmission.
  12. Pull transfer case and jack rearward to disengage transfer case.
  13. Remove transfer case from under vehicle.
scientia non olet · About LEMON Manuals