LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Commander Base, 4.7 N, AWD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Power Liftgate System (Service Information) >> Power Liftgate System - Service Information >> Switch - Full Open >> Removal

Switch - Full Open: Removal

Fig 1: Wire Connector And Full Open Switch Wire Terminals
GC0049023Courtesy of CHRYSLER LLC
  1. Open the liftgate.
  2. Disconnect and isolate the battery negative cable.
  3. Remove the power liftgate drive unit. See REMOVAL .
    CAUTION: Mark the position of the two full open switch wire terminals (2) in relation to their location in the liftgate drive unit wire connector (1).
  4. Using an appropriate wire terminal tool, carefully remove the full open switch wire terminals (2) from the liftgate drive unit connector (1).
    Fig 2: Power Liftgate Drive Unit And Full Open Switch
    GC0049026Courtesy of CHRYSLER LLC
  5. Remove the full open switch retaining screw (3) from the drive unit assembly (1).
    Fig 3: Full Open Switch Wire Harness Routing Clips And Power Liftgate Drive Unit Assembly
    GC0049027Courtesy of CHRYSLER LLC
  6. Carefully remove the full open switch wire harness routing clips (2) from the power liftgate drive unit assembly (1).
  7. Remove the full open switch and wire harness.
scientia non olet · About LEMON Manuals