LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Wrangler Rubicon, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Electronic Control Modules (Service Information)) >> Electronic Control Modules - Service Information >> Module-Antilock Brakes >> Removal >> Antilock Brake Module (ABM)

Antilock Brake Module (ABM)

WARNING: This page is about a different car, the 2007 Dodge Nitro. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Antilock Brake Module (ABM)
GC0056737Courtesy of CHRYSLER LLC
CAUTION: When removing ABM from HCU, be sure to completely separate the two components (approximately 38 mm (1.5 in.) before removing ABM. Otherwise, damage to the pressure sensor or Pump Motor connection may result requiring HCU replacement. Do not to touch the sensor terminals on the HCU side or the contact pads on the ABM side as this may result in contamination and issues in the future.
  1. Remove the negative battery cable from the battery.
  2. Pull up on the ABM harness connector release and remove connector.
  3. Remove the ABM module mounting screws (1) from the ABM unit.
scientia non olet · About LEMON Manuals