LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Liberty Sport, RWD, Standard >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Suspension System >> Front >> Hub/Bearing >> Installation >> Hub/Bearing

Suspension System: Front: Hub/Bearing: Installation: Hub/Bearing

  1. Install the hub/bearing assembly to the vehicle.
  2. Install the three mounting bolts for the hub/bearing. Tighten the bolt to 130 N.m (96 ft. lbs.).
  3. Install the axle shaft nut. Tighten the nut to 135 N.m (100 ft. lbs.). (if equipped with four wheel drive)
  4. Install the bracket to the wheel speed sensor wire.
  5. Install the wheel speed sensor to the hub. Tighten the bolt to 13.5 N.m (10 ft. lbs.). Refer to INSTALLATION .
  6. Install the disc brake rotor. Refer to INSTALLATION .
  7. Install the disc brake caliper adapter. Tighten the nut to 135 N.m (100 ft. lbs.). Refer to INSTALLATION .
  8. Install the tire and wheel assembly. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals