Diagnostic Test
- 1) DETERMINE ACTIVE OR STORED DTC NOTE: Ensure that the battery is fully charged.
Turn the ignition on.
Select ACTIVE or STORED DTC:
ACTIVE DTC
WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions could result in accidental airbag deployment and personal injury or death.WARNING: To avoid personal injury or death, turn the ignition off, disconnect the battery and wait two minutes before proceeding.- Replace the ORC in accordance with the Service information.
- Perform *AIRBAG SYSTEM VERIFICATION TEST - VER 1 .
STORED DTC
- Go to step 2).
- 2) CHECKING STORED OR INTERMITTENT CODES NOTE: Diagnose and repair all active codes before diagnosing stored codes. Refer to the appropriate airbag system diagnostic procedure.
With the scan tool, record and erase all Airbag System Module DTCs.
Turn the ignition off, wait 15 seconds, then turn the ignition on.
With the scan tool, check for active DTCs in the ORC.
Does the scan tool display any DTCs?
Yes
- Select the appropriate diagnostic procedure in the applicable article.
No
- No problem found at this time. Erase all codes before returning vehicle to customer.