LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Liberty Limited, 4WD, Automatic >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Distribution >> Junction Block >> Installation >> Installation - RHD

Installation - RHD

  1. Position the junction block and install the four junction block retaining screws.
  2. Install the upper and forward most group of relays in the junction block.
  3. Install the two ground wires on the right lower kick panel area.
  4. Working through the steering column opening cover, install the three bulkhead and two body controller electrical connectors on the junction block assembly.
  5. Install the courtesy lamp under the right side of the instrument panel.
  6. Install the right cowl trim panel on the vehicle. Refer to INSTALLATION .
  7. Install the instrument panel knee blocker. Refer to INSTALLATION .
  8. Install the right outboard trim bezel on the instrument panel.
  9. Install the right end cap on the instrument panel.
  10. Connect the negative battery cable.
scientia non olet · About LEMON Manuals