LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Liberty Limited, 4WD, Automatic >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Distribution >> Junction Block >> Installation >> Installation - LHD

Installation - LHD

NOTE: On vehicles equipped with a manual transmission, it will be helpful to depress the clutch pedal when installing the Junction Block under the instrument panel.
  1. Position the junction block and install the four junction block retaining screws.
  2. Install instrument panel wire harness on the lower channel of the instrument panel.
  3. Working through the steering column opening cover, install the three bulkhead and two body controller electrical connectors on the junction block assembly.
  4. Install the courtesy lamp under the left side of the instrument panel.
  5. Install the left cowl trim panel on the vehicle. Refer to INSTALLATION .
  6. Install the instrument panel knee blocker. Refer to INSTALLATION .
  7. Install the left outboard trim bezel on the instrument panel.
  8. Install the left end cap on the instrument panel.
  9. Connect the negative battery cable.
scientia non olet · About LEMON Manuals