LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Grand Cherokee Laredo, 3.0 M >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (3.7L Engine (Service Information)) >> Lubrication >> Sensor/Switch-Oil Pressure >> Installation

Sensor/Switch-Oil Pressure: Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Oil Pressure Sending Unit
GC0011823Courtesy of CHRYSLER LLC
  1. Install the oil pressure switch.
  2. Connect oil pressure switch connector.
  3. Install front splash shield.
  4. Lower vehicle.
  5. Connect the negative battery cable.
  6. Start the engine and ensure there are no oil leaks from the oil pressure switch.
scientia non olet · About LEMON Manuals