Diagnostic Test

1) VERIFY THAT DTC B2201-CALIBRATION MISMATCH IS ACTIVE
Turn the ignition on.

With the scan tool, read ORC DTC.

NOTE: Ensure the battery is fully charged.

Does the scan tool display active: B2201-CALIBRATION MISMATCH?

Yes
1. Go To 2).
No
1. Test Complete.
2) CHECK VIN IN PCM
With the scan tool compare the VIN that is programmed into the PCM to the VIN stored in the ORC.

Does the VIN programmed into the PCM match the VIN stored in the ORC?

Yes
1. Go To 3).
No
1. Replace and program the Powertrain Control Module in accordance with the service information. Ensure the PCM is replaced with the correct vehicle line PCM.
3) REPLACE THE OCCUPANT RESTRAINT CONTROLLER
WARNING: To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.

WARNING: If the airbag control module is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and serious or fatal injury.

View repair.

Repair
1. Replace the ORC in accordance with the service information.
2. Perform *AIRBAG SYSTEM VERIFICATION TEST - VER 1 .