LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Compass Limited, AWD, Standard >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Message Center System (Service Information) >> Electronic Vehicle Information Center >> Installation >> Installation-Remote Compass Module

Installation-Remote Compass Module

NOTE: The Remote Compass Module (RCM) must be calibrated after installation. See STANDARD PROCEDURE  for the appropriate procedure.
  1. Position the Remote Compass Module on top of the instrument panel.
  2. Install the screws that secure the RCM to the instrument panel.
  3. Connect the RCM electrical connector.
    Fig 1: I/P UPPER TRIM
    GC0053494Courtesy of CHRYSLER LLC
  4. Install the trim cover over the center bezel and seat fully.
  5. Connect the battery negative cable.
  6. Calibrate the compass module. See STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals