Diagnostic Test

1) INTERMITTENT CONDITION
Turn the ignition on.

With the Scan Tool, clear all TIPM DTC's.

Turn the Washer Pump Motor on.

With the Scan Tool read the DTC information.

Does the Scan Tool read: B2368-WINDOW WASHER MOTOR 1 CONTROL CIRCUIT LOW?

Yes
1. Go To 2).
No
1. The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
2. Perform BODY VERIFICATION TEST - VER 1 .
2) (W10) WASHER PUMP MOTOR CONTROL CIRCUIT SHORTED TO GROUND

Fig 1: Measuring Resistance Between Ground And Washer Pump Motor Control Circuit
Courtesy of CHRYSLER LLC

Turn the ignition off.

Disconnect the TIPM C1 harness connector.

Disconnect the Washer Pump Motor harness connector.

Measure the resistance between ground and the (W10) Washer Pump Motor Control circuit.

Is the resistance below 5.0 ohms?

Yes
1. Repair the (W10) Washer Pump Motor Control Output circuit for a short to ground.
2. Perform BODY VERIFICATION TEST - VER 1 .
No
1. Go To 3).
3) WASHER PUMP MOTOR
Reconnect the TIPM C1 harness connector.

Turn the ignition on.

With the Scan Tool, clear all TIPM DTC's.

Turn the Washer Pump Motor on.

With the Scan Tool read the DTC information.

Does the Scan Tool read: B2368-WINDOW WASHER MOTOR 1 CONTROL CIRCUIT LOW?

Yes
1. Replace the Totally Integrated Power Module (TIPM) in accordance with the service information.
2. Perform BODY VERIFICATION TEST - VER 1 .
No
1. Replace the Washer Pump Motor in accordance with the service information.
2. Perform BODY VERIFICATION TEST - VER 1 .