Diagnostic Test

1) INTERMITTENT CONDITION
Turn the ignition on.

With the Scan Tool, clear all TIPM DTC's.

Turn the Front Wipers on.

With the Scan Tool, read the Front Wiper DTC's.

Does the Scan Tool read: B2367-WINDOW WASHER MOTOR 1 CONTROL CIRCUIT?

Yes
1. Go To 2).
No
1. The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
2. Perform BODY VERIFICATION TEST - VER 1 .
2) (W10) FRONT WASHER PUMP MOTOR CONTROL CIRCUIT SHORT TO VOLTAGE

Fig 1: Measuring Voltage On Front Washer Pump Motor Control Circuit
Courtesy of CHRYSLER LLC

Turn the ignition off.

Disconnect the Front Washer Pump Motor harness connector.

Disconnect the TIPM C1 harness connector.

Measure the voltage on the (W10) Front Washer Pump Motor Control circuit.

Is the voltage above 5.0 volts?

Yes
1. Repair the (W10) Front Washer Pump Motor Control circuit for a short to voltage.
2. Perform BODY VERIFICATION TEST - VER 1 .
No
1. Replace the Totally Integrated Power Module in accordance with the service information.
2. Perform BODY VERIFICATION TEST - VER 1 .