Diagnostic Test

Turn the ignition on, then off, and then on again.

With the scan tool, read Amplifier DTCs.

Does the scan tool display active: B1470-CHANNEL 4 AUDIO SPEAKER OUTPUT CIRCUIT LOW? 

Yes 

1. Go To  2).

No 

1. The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
2. Perform BODY VERIFICATION TEST - VER 1 .

Fig 1: Checking (X154) Amplified Right Front Door Speaker (-) Circuit

Courtesy of CHRYSLER LLC

Disconnect the Amplifier C2 harness connector.

Disconnect the Right Front Door Speaker harness connector.

Measure the resistance between ground and the (X154) Amplified Right Front Door Speaker (-) circuit.

Is the resistance below 10K ohms? 

Yes 

1. Repair the (X154) Amplified Left Front Door Speaker (-) circuit for a short to ground.
2. Perform BODY VERIFICATION TEST - VER 1 .

No 

1. Go To  3).

Fig 2: Checking (X156) Amplified Right Front Door Speaker (+) Circuit

Courtesy of CHRYSLER LLC

Measure the resistance between ground and the (X156) Amplified Right Front Door Speaker (+) circuit.

Is the resistance below 10K ohms? 

Yes 

1. Repair the (X156) Amplified Right Front Door Speaker (+) for a short to ground.
2. Perform BODY VERIFICATION TEST - VER 1 .

No 

1. Go To  4).

Fig 3: Checking Right Front Door Speaker

Courtesy of CHRYSLER LLC

Turn the ignition off.

Reconnect and reinstall the Right Front Door Speaker.

Measure the resistance of the speaker circuit between the Amplifier C2 harness connector and ground.

Is the resistance below 10K ohms? 

Yes 

1. Replace the Right Front Door Speaker in accordance with the service information.
2. Perform BODY VERIFICATION TEST - VER 1 .

No 

1. Replace the amplifier in accordance with the service information.
2. Perform BODY VERIFICATION TEST - VER 1 .