Diagnostic Test

1) CHECK IF THE DTC IS ACTIVE
With the scan tool, read Transmission DTCs.

Is the status Active for this DTC or is the STARTS SINCE SET counter 2 or less?

Yes
1. Go To 2).
No
1. Go To 4).
2) CHECK FOR FCM/TIPM CAN BUS DTCS
With the scan tool, read FCM DTCs.

Are there any FCM/TIPM CAN BUS DTCs present?

Yes
1. Refer to DIAGNOSIS AND TESTING and perform the appropriate symptom(s).
2. Perform CVT VERIFICATION TEST .
No
1. Go To 3).
3) CHECK IF ABS DTCS ARE PRESENT
With the scan tool, read ABS DTCs.

Are there any ABS DTCs present?

Yes
1. Refer to ABS - ELECTRICAL DIAGNOSTICS article and perform the appropriate symptom(s).
2. Perform CVT VERIFICATION TEST .
No
1. Using the schematics as a guide, check the Transmission Control Module (TCM) pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the TCM per the Service Information. Refer to REMOVAL .
2. Perform CVT VERIFICATION TEST .
4) INTERMITTENT WIRING AND CONNECTORS
The conditions necessary to set this DTC are not present at this time.

Using the schematics as a guide, inspect the wiring and connectors specific to this circuit.

Wiggle the wires while checking for shorted and open circuits.

Were there any problems found?

Yes
1. Repair as necessary.
2. Perform CVT VERIFICATION TEST .
No
1. Test Complete.