Key/Lock Cylinder

The key lock cylinder may be removed without removing the switch assembly, although the original ignition key must be used.

Fig 1: Ignition Switch Bezel

Courtesy of CHRYSLER LLC

1. Disconnect negative cable from battery.
2. Use a plastic trim removal stick (2) to remove switch bezel (1). Bezel snaps on.
   Fig 2: Key Cylinder Release Tab

   Courtesy of CHRYSLER LLC
3. To remove key lock cylinder (1) from housing (2), rotate key to ON position while pressing on release tab (3). This tab (3) is located on the right side of the switch assembly.
   Fig 3: Key Lock Cylinder Removal/Installation

   Courtesy of CHRYSLER LLC
4. Pull key lock cylinder (1) from housing (2) for removal.