LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Commander Base, 4.7 P, AWD >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Overhead Console (Service Information) >> Overhead Console - Service Information >> Installation >> Overhead Console

Overhead Console

Fig 1: Identifying Overhead Console Components (Rear View)
GC0045539Courtesy of CHRYSLER LLC
  1. Position the overhead console near the mounting location on the headliner.
  2. Feed the inside rearview mirror wire harness through the mounting hole (4).
  3. Reconnect the roof wire harness connectors to the Electronic Overhead Module (EOM) (3) and combination power sunroof/liftgate switch (2) if equipped.
  4. Align the snap clips (1) on the overhead console housing with their receptacles in the overhead console bracket.
    Fig 2: View Of Sunroof Instrument Panel
    GC0065077Courtesy of CHRYSLER LLC
  5. Push upward firmly and evenly on the sides of the overhead console housing (3) over the snap clip locations until the snap clip is fully engaged with its receptacle in the overhead console bracket.
  6. Install the inside rearview mirror. Refer to INSTALLATION .
  7. Reconnect the battery negative cable.
scientia non olet · About LEMON Manuals