LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Commander Base, 4.7 P, AWD >> Repair and Diagnosis (Single Page) >> Brakes >> Traction Control >> Anti-Lock Brake System - Electrical Diagnostics >> Abs - Electrical Diagnostics >> DTC Troubleshooting >> C1242-G Sensor Input Signal Performance >> Monitor Conditions

Monitor Conditions

  1. When Monitored: 

    Continuously after power-on reset until vehicle speed exceeds 12.4 mph/20 kph for the first time, but not if the sensor voltage is out of range,

    Or, during diagnostic mode.

    Or, if the monitoring was inhibited by a corresponding diagnostics command.

    Or, if the vehicle speed has exceeded 12.4 mph/20 kph during the actual ignition cycle.

    Or, if at least one over spinning wheel is detected.

    Or, if one of the control functions is active.

scientia non olet · About LEMON Manuals