Speed Control Servo

Fig 1: Identifying Speed Control Components

Courtesy of CHRYSLER LLC

1 - Air Cleaner Box

2 - Vacuum Line

3 - Speed Control Servo

4 - Cross Support

5 - Electrical. Connector

6 - Servo Mounting Bracket

7 - Servo Mounting Bolt

8 - Vacuum Reservoir Mounting Bolt

9 - Vacuum Reservoir

The speed control servo assembly (3) is attached to a cross-support (4) located in the engine compartment.

Disconnect negative battery cable at battery.
Disconnect vacuum line at servo.
Disconnect electrical connector (5) at servo.
Remove servo mounting bolt (7).
Disconnect servo cable at throttle body. Refer to SERVO CABLE Removal/Installation.

Fig 2: View Of Servo, Cable Sleeve, Retaining Clip & Mounting Nuts
Courtesy of CHRYSLER LLC
Remove 2 mounting nuts (1) holding servo cable sleeve (4) to bracket.
Pull speed control cable sleeve and servo away from servo mounting bracket to expose cable retaining clip (3) and remove clip. Note: The servo mounting bracket displayed is a typical bracket and may/may not be applicable to this model vehicle.
Remove servo (2) from mounting bracket. While removing, note orientation of servo to bracket.