LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Commander Base, 4.7 P, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (NV140 Transfer Case (Service Information)) >> NV140 - Service Information >> Removal >> Transfer Case - NV140/NV146

Transfer Case - NV140/NV146

WARNING: This page is about a different variant/trim than selected.
Fig 1: Identifying MP140 Transfer Case, Nuts, Transmission & Transfer Case Vent Tube
GC0027348Courtesy of CHRYSLER LLC
1 - NV140 TRANSFER CASE
2 - NUTS
3 - TRANSMISSION
4 - TRANSFER CASE VENT TUBE
  1. Raise vehicle.
    CAUTION: Do not allow prop shafts to hang at attached end. Damage to joint can result.
  2. Remove the front and rear propeller shafts. Refer to REMOVAL .
  3. Support transmission with jack stand.
  4. Remove rear crossmember and skid plate, if equipped.
  5. Disconnect transfer case vent hose (4). See Fig 1.
  6. Disconnect the wiring connector from the shift motor, if necessary.
  7. Support transfer case with transmission jack and secure with chains.
  8. Remove nuts (2) attaching transfer case (1) to transmission (3).
  9. Pull transfer case and jack rearward to disengage transfer case.
  10. Remove transfer case from under vehicle.
scientia non olet · About LEMON Manuals