LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Commander Base, 4.7 N, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine & Automatic Transmission Cooling System >> Engine >> Sensor-Engine Coolant Temperature >> Removal >> Removal-3.0L Diesel

Removal-3.0L Diesel

Fig 1: ETC Sensor Removing/Installing - 3.0L
GC0044887Courtesy of CHRYSLER LLC
WARNING: Risk of injury to skin and eyes from scalding with hot coolant. Risk of poisoning from swallowing coolant. Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly to release pressure. Store coolant in suitable and appropriately marked container. Wear protective gloves, clothes and eye wear.
  1. Disconnect negative battery cable.
  2. Remove engine cover.
  3. Partially drain coolant system. See STANDARD PROCEDURE .
  4. Unplug coolant temperature sensor electrical connector.
    NOTE: Capture any residual coolant that may flow.
  5. Remove coolant temperature sensor.
scientia non olet · About LEMON Manuals