LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2007 >> Commander Base, 4.7 N, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine & Automatic Transmission Cooling System >> Engine >> Pump-Water >> Installation >> Installation-3.0L Diesel

Installation-3.0L Diesel

Fig 1: View Of 3.0L Water Pump
GC0044889Courtesy of CHRYSLER LLC
  1. Clean all sealing surfaces.
  2. Position and install water pump. Tighten M6 bolts to 14 N.m (124 lbs. in.) and M8 bolts to 20 N.m (177 lbs. in.).
  3. Install idler pulley. Tighten bolt to 35 N.m (26 lbs. ft.).
  4. Install coolant hoses.
  5. Install accessory drive belt. See INSTALLATION .
  6. Close coolant drain.
  7. Install engine cover.
  8. Connect negative battery cable.
  9. Fill coolant system to proper level with the appropriate coolant mixture. See STANDARD PROCEDURE .
  10. Start engine and inspect for leaks.
scientia non olet · About LEMON Manuals