Technical Service Bulletins: Other Variant

WARNING: This page is about the Wrangler SE, 2.4 1, Automatic, which is a different variant/trim than selected.

A/C Compressor
- Fluid Flushing Requirements (26-003-07)
Accessories Control Systems
- Scan Tool Support Before And After Collision Repair (31-002-16)
- Co-Pilot Support And Correct Cable Usage (18-029-05)
Accessory Drive Belts
- 2.4L Engine - Chirp-Like Sound From Accessory Drive Belt (07-003-05)
Air Bag, SRS
- Replacement Seat Covers And Seat Cover Repairs (31-004-11)
- Salvaged Airbags Or Other Salvaged Restraint System Component Usage (31-003-11)
Anti-Theft Systems
- Powertrain Control Module Initialization (08-030-06 REV.A)
Automatic Trans
- Fluid Flushing Requirements (26-004-12)
- Fluid Flushing Requirements (26-003-07)
- Automatic Transmission Diagnostic Tear Down Procedure (21-021-08)
- Automatic Transmission Fluid Usage ATF+4 (Type Ms9602) (21-014-07)
Body Interior
- Scan Tool Support Before And After Collision Repair (31-002-16)
Communication Devices
- Radio Communication Equipment Installation Recommendations (08-024-05)
Cooling System (Mechanical)
- Keep The Cooling System Free Of Debris And Corrosion To Prevent Premature Water Pump Failure (TT002-13)
Differentials & Drive Axles
- A Self-Sustaining Vibration (Shimmy) Of The Vehicle And Steering Wheel While Driving At Speeds Typically Above 50 Mph (80 KMH) (19-002-12)
Engine Control Systems
- I/M Readiness Check Continues To Indicate OBD System Is Not Ready For I/M Testing (X51 LIFTETIME Warranty Extension) (25-005-13 REV. A)
- Flash: Mil Illumination Due To Diagnostic Trouble Code P0340 Or P0344 (18-015-09)
- Powertrain Control Module Initialization (08-030-06 REV.A)
- Co-Pilot Support And Correct Cable Usage (18-029-05)
Exhaust
- Flash: DTC P0420 / P0430 - Catalyst Efficiency (18-046-07)
Exterior Body Panels
- Scan Tool Support Before And After Collision Repair (31-002-16)
- Do Not Apply Corrosion Protection On Sheet Molding Compound (SMC) Plastic Panels (31-005-12)
- Blending CLEARCOAT During The Refinish Process (31-002-13)
- OVERSPRAY Removal (31-001-13)
- Welded Sheet Metal Repairs And Replacements (31-007-12)
- Front Fascia Repair When License Plate Bracket Has Been Removed (31-004-12)
- Repair Parts Used For Structural Repairs (31-002-11)
- Use Of Heat To Straighten Damaged Components (31-001-11)
- Hard To Fill With Fuel Or Fuel Nozzle Shuts Off Repeatedly (14-001-09 REV. A)
Exterior Lights
- Exterior Lamp Condensation And Fogging (08-091-14)
Frames, Subframes & Crossmembers
- Repair Parts Used For Structural Repairs (31-002-11)
Front Suspension
- Shock Strut Weeping Condition Identification (02-001-15)
Fuel System
- Hard To Fill With Fuel Or Fuel Nozzle Shuts Off Repeatedly (14-001-09 REV. A)
- Loose Fuel Cap Message Or Mil Illumination For Diagnostic Trouble Code P0457 - EVAP System - Loose Fuel Cap (14-001-06)
Gauges & Instrument Panels
- I/M Readiness Check Continues To Indicate OBD System Is Not Ready For I/M Testing (25-001-07)
Headlights
- Exterior Lamp Condensation And Fogging (08-091-14)
HVAC Control Systems
- A/C Cooling Coil Odor (24-013-05)
Identification
- Safety Certification And Tire Pressure Label Replacement Guidelines (31-002-18)
Interior/Exterior Trim
- Replacement Seat Covers And Seat Cover Repairs (31-004-11)
Lubrication System
- Fluid Flushing Requirements (26-004-12)
- Fluid Flushing Requirements (26-003-07)
Manual Steering
- Fluid Flushing Requirements (26-004-12)
Mechanical
- Hydraulic Versus Mechanical TENSIONERS (TT001-13)
- Fluid Flushing Requirements (26-003-07)
Mechanical - Hydraulic
- Fluid Flushing Requirements (26-004-12)
- Fluid Flushing Requirements (26-003-07)
Paint & Coatings
- Do Not Apply Corrosion Protection On Sheet Molding Compound (SMC) Plastic Panels (31-005-12)
- Blending CLEARCOAT During The Refinish Process (31-002-13)
- OVERSPRAY Removal (31-001-13)
- Front Fascia Repair When License Plate Bracket Has Been Removed (31-004-12)
- Paint Repair - Etching (23-046-07)
Rear Suspension
- Shock Strut Weeping Condition Identification (02-001-15)
Restraints Control Systems
- Salvaged Airbags Or Other Salvaged Restraint System Component Usage (31-003-11)
Schedule
- Fluid Flushing Requirements (26-004-12)
Seats
- Replacement Seat Covers And Seat Cover Repairs (31-004-11)
Steering Column
- Steering Wheel Not Centered (02-002-15)
- Steering Shimmy (19-003-06)
Steering Control Systems
- A Self-Sustaining Vibration (Shimmy) Of The Vehicle And Steering Wheel While Driving At Speeds Typically Above 50 Mph (80 KMH) (19-002-12)
Steering Linkage
- A Self-Sustaining Vibration (Shimmy) Of The Vehicle And Steering Wheel While Driving At Speeds Typically Above 50 Mph (80 KMH) (19-002-12)
- Wheel Bearing And Hub Replacement/Inspection Guidelines During Collision Repairs (31-001-12)
System
- I/M Readiness Check Continues To Indicate OBD System Is Not Ready For I/M Testing (X51 LIFTETIME Warranty Extension) (25-005-13 REV. A)
- Flash: Mil Illumination Due To Diagnostic Trouble Code P0340 Or P0344 (18-015-09)
- Flash: DTC P2074 - 2.4L - Map/TPS Correlation (18-007-08)
- Flash: DTC P0420 / P0430 - Catalyst Efficiency (18-046-07)
- I/M Readiness Check Continues To Indicate OBD System Is Not Ready For I/M Testing (25-001-07)
- Loose Fuel Cap Message Or Mil Illumination For Diagnostic Trouble Code P0457 - EVAP System - Loose Fuel Cap (14-001-06)
- Co-Pilot Support And Correct Cable Usage (18-029-05)
Transmission Control Systems
- Co-Pilot Support And Correct Cable Usage (18-029-05)
Wheel Alignment
- Steering Wheel Not Centered (02-002-15)
- Vehicle Pulls Or Leads Right Or Left (02-003-15)
Wheel Hubs
- Wheel Bearing And Hub Replacement/Inspection Guidelines During Collision Repairs (31-001-12)
Wheels & Tire System
- Safety Certification And Tire Pressure Label Replacement Guidelines (31-002-18)
- Steering Wheel Vibration Diagnostic Procedure (22-001-14 REV. A)
- Wheel Bearing And Hub Replacement/Inspection Guidelines During Collision Repairs (31-001-12)
- Reconditioned Wheel Usage (31-005-11)
Window Motors & Regulators
- Cracked Windshield (23-047-06)
- Circular/Ring Marks On Glass (23-035-05)
Wiper/Washer Systems
- Windshield Wiper Blade/Element Maintenance (23-037-15)