PDC B(+) Terminal Module

INSTALLATION 

Fig 1: PDC B(+) Terminal Module Remove/Install

Courtesy of DAIMLERCHRYSLER CORP.

1. From the bottom of the PDC housing (1), align and insert the B(+) terminal module (3) into the PDC.
2. From the bottom of the PDC housing (1), align and insert the two studs of the PDC B(+) terminal module (3) through the bus bar (4) in the PDC.
3. From the bottom of the PDC housing (1), press the B(+) terminal module (3) gently and evenly into the PDC until both of the latches (2) are fully engaged.
4. Install the PDC housing lower cover.