LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Liberty Renegade, 4WD, Automatic, 42RLE/VLP >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Suspension System >> Rear >> Upper Control Arm >> Removal

Upper Control Arm: Removal

Fig 1: Upper Suspension Arm Mounting Bolt
GC0025580Courtesy of DAIMLERCHRYSLER CORP.
1 - UPPER SUSPENSION ARM
2 - MOUNTING BOLT
  1. Raise and support the vehicle.
  2. Support the rear axle with a hydraulic jack.
  3. Remove the ball joint pinch bolt from the top of the differential housing bracket. See Figure.
  4. Remove partial nuts from the heat shield in order to lower the shield down enough to get the proper clearance to remove the right side bolt (2) from the body.
  5. Remove the upper suspension arm mounting bolts (2) from the body and remove the arm (1). See Fig 1.
    Fig 2: Ball Joint Bracket
    GC0025581Courtesy of DAIMLERCHRYSLER CORP.
    1 - UPPER BALL JOINT
    2 - SUPPORT BRACKET BOLTS
  6. Remove the support bracket mounting bolts (2) if needed. See Fig 2.
scientia non olet · About LEMON Manuals