LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Liberty Renegade, 4WD, Automatic, 42RLE/VLP >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Suspension System >> Front >> Knuckle >> Removal

Suspension System: Front: Knuckle: Removal

  1. Raise and support the vehicle.
  2. Remove the tire and wheel assembly.
  3. Remove the caliper adapter. (Refer to BRAKES/HYDRAULIC/MECHANICAL/DISC BRAKE CALIPER ADAPTER - REMOVAL) .
    CAUTION: Never allow the disc brake caliper to hang from the brake hose. Damage to the brake hose will result. Provide a suitable support to hang the caliper securely.
  4. Remove the disc brake rotor. (Refer to BRAKES/HYDRAULIC/MECHANICAL/ROTORS - REMOVAL) .
  5. Remove the wheel speed sensor. (Refer to BRAKES/ELECTRICAL/FRONT WHEEL SPEED SENSOR - REMOVAL) .
  6. Remove the axle shaft nut. (if equipped with four wheel drive)
  7. Remove the hub/bearing. (Refer to SUSPENSION/FRONT/HUB / BEARING - REMOVAL) .
  8. Separate the outer tie rod end from the steering knuckle. (Refer to STEERING/LINKAGE/TIE ROD END - REMOVAL) .
  9. Remove the lower ball joint nut.
  10. Separate the lower ball joint from the suspension arm using tool C-4150A.
  11. Remove the upper ball joint nut.
  12. Separate the upper ball joint from the knuckle using tool C-4150A.
  13. Remove the knuckle from the vehicle.
scientia non olet · About LEMON Manuals