LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Commander Limited, 5.7 2, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Switch-Speed Control >> Removal

Switch-Speed Control: Removal

Fig 1: Identifying Speed Control Switch
GC0010425Courtesy of DAIMLERCHRYSLER CORP.
WARNING: Before attempting to diagnose, remove or install any airbag system or related steering wheel and steering column components you must first disconnect and isolate the negative (ground) battery cable. Wait 2 minutes for system capacitor to discharge before further system service. Failure to do so could result in accidental deployment and possible personal injury. Refer to the RESTRAINTS - SERVICE INFORMATION article.
  1. Disconnect and isolate negative battery cable from battery.
  2. Remove airbag module. Refer to the RESTRAINTS - SERVICE INFORMATION article.
  3. Unplug electrical connector.
  4. Remove speed control switch mounting screw (1) and remove switch from steering wheel.
scientia non olet · About LEMON Manuals