LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Commander Base, 4.7 N, RWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System >> Generator >> Installation >> 3.7L / 4.7L

3.7L / 4.7L

Fig 1: Removing/Installing Generator - 3.7L/4.7L
G04283380Courtesy of DAIMLERCHRYSLER CORP.
  1. Position generator (3) to engine and install 2 horizontal bolts (1) and 1 vertical bolt (2).
  2. Tighten all 3 bolts to 40 ft. lbs. (55 N.m).
    Fig 2: Locating Generator & Connectors - 3.7L/4.7L
    GC0008572Courtesy of DAIMLERCHRYSLER CORP.
  3. Snap field wire connector (4) into rear of generator.
  4. Install B+ terminal eyelet to generator output stud. Tighten mounting nut (2) to 108 in. lbs. (12 N.m).
    CAUTION: Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.
    CAUTION: When installing a serpentine accessory drive belt, the belt MUST be routed correctly. The water pump may be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment, or refer to BELTS-ACCESSORY DRIVE .
  5. Install generator drive belt.
  6. Install negative battery cable to battery.
scientia non olet · About LEMON Manuals