LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Commander Base, 4.7 N, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (3.7L Engine (Service Information)) >> Flex Plate >> Installation

Flex Plate: Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Flexplate Bolt Loosening/Tightening Sequence
GC0011786Courtesy of DAIMLERCHRYSLER CORP.
1 - FLEXPLATE
  1. Position the flexplate onto the crankshaft and install the bolts hand tight.
  2. Tighten the flexplate retaining bolts to 95 N.m (70 ft. lbs.) in the sequence shown. See Fig 1.
  3. Install the transmission. (Refer to TRANSMISSION - INSTALLATION ).
scientia non olet · About LEMON Manuals