LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Commander Base, 4.7 N, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 189 (Starting System (Service Information)) >> Starter >> Installation >> 5.7L/6.1L

Section 189 (Starting System (Service Information)): Starter: Installation: 5.7L/6.1L

WARNING: This page is about a different car, the 2009 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: STARTER R/I - 5.7L/6.1L
GC0104231Courtesy of CHRYSLER LLC
  1. Connect solenoid wire to starter motor (snaps on).
  2. Position battery cable to solenoid stud. Install and tighten battery cable eyelet nut. Torque nut to 25 N.m (19 ft. lbs.). Do not allow starter motor to hang from wire harness.
  3. Position starter motor (1) to engine.
  4. If equipped with automatic transmission, slide cooler tube bracket into position.
  5. Install and tighten both mounting bolts (2). Torque bolts to 68 N.m (50 ft. lbs.).
  6. Lower vehicle.
  7. Connect negative battery cable.
scientia non olet · About LEMON Manuals