LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2006 >> Commander Base, 4.7 N, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 188 (Charging System (Service Information)) >> Generator >> Installation >> 3.7L / 4.7L

3.7L / 4.7L

WARNING: This page is about a different car, the 2009 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing / Installing Generator - 3.7L / 4.7L
GC0082801Courtesy of CHRYSLER LLC
  1. Position generator (3) to engine and install 2 horizontal bolts (1) and 1 vertical bolt (2).
  2. Tighten all 3 bolts to 40 ft. lbs. (55 N.m).
    Fig 2: Generator Connectors - 3.7L / 4.7L
    GC0082800Courtesy of CHRYSLER LLC
  3. Snap field wire connector (4) into rear of generator.
  4. Install B+ terminal eyelet to generator output stud. Tighten mounting nut (2) to 108 in. lbs. (12 N.m).
    CAUTION: Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.
    CAUTION: When installing a serpentine accessory drive belt, the belt must be routed correctly. The water pump may be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment, or Refer to BELT, SERPENTINE
  5. Install generator drive belt.
  6. Install negative battery cable to battery.
scientia non olet · About LEMON Manuals